In Spanish In Hmong In Somali
Installation Checklist 5: Forward-facing Only Car Seat Important: This is a general checklist designed to be used in combination with your vehicle owner’s manual and your child car seat instruction manual. To get the most out of this checklist, have those manuals handy for quick reference.
___ 1) Check that the car seat is correct for the child’s weight and height.
Height and weight limits vary by manufacturer; check labels on the car seat for specific limits.
___ 2) Place the car seat in the back seat of the vehicle.- If the vehicle is an SUV or van with three rows of seats, place the car seat in the middle row.
- Place the car seat in the center of the vehicle seat, if possible (see vehicle owner’s manual).
- The car seat should face the front of the vehicle.
___ 3) Select one method only to install the car seat.- Lap belt only (usually found in middle of the back seat)
- Lap and shoulder belt
- LATCH system (Lower Anchors and Tethers for Children, built into the vehicle – see below)
___ 4) Attach the car seat. Important: You must check labels on the car seat and the car seat instruction manual for information on how to attach the car seat using either the lap belt, lap and shoulder belt, or LATCH system. Also check your vehicle owner’s manual for instructions, including whether you need to use a locking clip.- Position the car seat so the child rides sitting upright–see photo.
___ 5) Tighten the vehicle belt or lower anchor attachment (LATCH).- The car seat must not move more than one inch from side to side or front to back at the point of attachment. Have another person push down firmly on the child car seat while you tighten the vehicle belt, or kneel on the car seat yourself while you tighten the vehicle belt.
- Attach the top tether and tighten.
___ 6) Buckle the child into the car seat (see photo).- Use the right harness slots. Harness straps should be at or above the child’s shoulders for forward-facing.
- Check that the harness straps are snug and flat on the child’s shoulders.
- Check that the plastic harness retainer clip is at the child’s armpit level.
- The child’s back should be flat against the back of the car seat.
Source: National Highway Traffic Safety Administration, U.S. Department of Transportation
See how to do it on video: "Car Safety for Your Toddler" linked from http://www.chop.edu/carseat
|
|
|
|
|